TY - JOUR AU - Aguanell García, M. PY - 1989/09/30 Y2 - 2024/03/28 TI - Crack development through plastic shrinkage in fresh concretes and mortars JF - Materiales de Construcción JA - Mater. constr. VL - 39 IS - 215 SE - Research Articles DO - 10.3989/mc.1989.v39.i215.799 UR - https://materconstrucc.revistas.csic.es/index.php/materconstrucc/article/view/799 SP - 5-18 AB - The rate of water evaporation in the exposed surfaces plays an important part in the development of cracks in fresh concretes and mortars before hardening is completed. This rate of evaporation depends on the drying power of the wind sweeping such surfaces as a function of the relative humidity, temperature and speed of the air. After many studies and research work on the subject of plastic cracking, the following axiom has been established: "Plastic shrinkage and cracking of concrete surfaces take place when water evaporates from the surface quicker than it can be replaced through exudation". Once the value of weather parameters are known, the extent of the risk of crack development can be known and preventive steps taken to overcome such risk. Obviously, such steps are all oriented to reducing or stopping evaporation and go from covering surfaces with wet sackcloth or plastic foil, through sprinkling water mists or lowering the concrete temperature, to using film-forming curing products. Another additional measure can be the addition of polypropelene fibers to the concrete while in the mixer, at the rate of 0.9 kg fiber to 1 m<sup>3</sup> of concrete. ER -