Compression performance and bearing capacity calculation model of small-eccentricity columns strengthened with textile-reinforced mortar (TRM)
DOI:
https://doi.org/10.3989/mc.2019.08418Keywords:
Composite, Fiber reinforcement, Mechanical properties, ModelizationAbstract
To study the compression performance of TRM-strengthened columns with small eccentricities, a total of 9 reinforced concrete (RC) columns with end corbels were subjected to compression testing. The test parameters are as follows: the number of textile layers, the ratio of longitudinal reinforcement, and polyvinyl alcohol (PVA) short-cut fiber volume fraction. The experimental results indicated that, compared to the control, columns with three layers of textile exhibited an approximately 10.66% increase in the bearing capacity. However, the effect increased only slightly when the number of textile layers increased to 4. Besides, the effect was improved with the increase in the ratio of longitudinal reinforcement and PVA fiber volume fraction. Finally, based on laboratory tests and related research results, a model for calculating normal section bearing capacity of TRM-strengthened columns with small eccentricities was presented. A comparison of the theoretical and experimental data demonstrated the applicability of the proposed model.
Downloads
References
Bournas, D.A.; Pavese, A.; Tizani, W. (2015) Tensile capacity of FRP anchors in connecting FRP and TRM sheets to concrete. Eng. Struct. 82, 72-81. https://doi.org/10.1016/j.engstruct.2014.10.031
Bisby, L.; Ranger, M. (2010) Axial-flexural interaction in circular FRP-confined reinforced concrete columns. Constr. Build. Mater. 24 [9], 1672-1681. https://doi.org/10.1016/j.conbuildmat.2010.02.024
Ombres, L.; Verre, S. (2015) Structural behaviour of fabric reinforced cementitious matrix (FRCM) strengthened concrete columns under eccentric loading. Compos. Pt. B-Eng. 75, 235-249. https://doi.org/10.1016/j.compositesb.2015.01.042
Xu, S.L.; Li, H. (2007) Bond Properties and Experimental Methods of Textile Reinforced Concrete. J. Wuhan Univ. Technol.-Mat. Sci. Edit. 22 [3], 529-532. https://doi.org/10.1007/s11595-006-3529-9
Mechtcherine, V. (2013) Novel cement-based composites for the strengthening and repair of concrete structures. Constr. Build. Mater. 41, 365-373. https://doi.org/10.1016/j.conbuildmat.2012.11.117
Papanicolaou, C.G.; Triantafillou, T.C.; Karlos, K.; Papathanasiou, M. (2007) Textile-reinforced mortar (TRM) versus FRP as strengthening material of URM walls: In-plane cyclic loading. Mater. Struct. 40 [10], 1081-1097. https://doi.org/10.1617/s11527-006-9207-8
Trapko, T. (2014) Behaviour of fibre reinforced cementitious matrix strengthened concrete columns under eccentric compression loading. Mater. Des. 54 [2], 947-954. https://doi.org/10.1016/j.matdes.2013.09.008
Sheng, J.; Yin, S.P.; Wang, F. (2017) Experimental study on the fatigue behaviour of RC beams strengthened with TRC after sustained load corrosion. Constr. Build. Mater. 131, 713-720. https://doi.org/10.1016/j.conbuildmat.2016.11.030
Elsanadedy, H.M.; Almusallam, T.H.; Alsayed, S.H.; Alsalloum, Y.A. (2013) Flexural strengthening of RC beams using textile reinforced mortar-Experimental and numerical study. Compos. Struct. 97 [2], 40-55. https://doi.org/10.1016/j.compstruct.2012.09.053
Larbi, A.S.; Agbossou, A.; Hamelin, P. (2013) Experimental and numerical investigations about textile-reinforced concrete and hybrid solutions for repairing and/or strengthening reinforced concrete beams. Compos. Struct. 99, 152-162. https://doi.org/10.1016/j.compstruct.2012.12.005
Schladitz, F.; Frenzel, M.; Ehlig, D.; Curbach, M. (2012) Bending load capacity of reinforced concrete slabs strengthened with textile reinforced concrete. Eng. Struct. 40, 317-326. https://doi.org/10.1016/j.engstruct.2012.02.029
Triantafillou, T.C.; Papanicolaou, C.G.; Zissimopoulos, P.; Laourdekis, T. (2006) Concrete confinement with textilereinforced mortar jackets. ACI Struct. J. 103 [1], 28-37. https://doi.org/10.14359/15083
Bournas, D.A.; Lontou, P.V.; Papanicolaou, C.G.; Triantafillou, T.C. (2007) Textile-reinforced mortar versus fiber-reinforced polymer confinement in reinforced concrete columns. ACI Struct. J. 104 [6], 740-748. https://doi.org/10.14359/18956
Trapko, T. (2013) Stress-strain model for FRCM confined concrete elements. Compos. Pt. B-Eng. 45 [1], 1351-1359. https://doi.org/10.1016/j.compositesb.2012.07.001
Yin, S.P.; Xu, S.L.; Wang, F. (2015) Investigation on the flexural behavior of concrete members reinforced with epoxy resin-impregnated textiles. Mater. Struct. 48 [1-2], 153-166. https://doi.org/10.1617/s11527-013-0174-6
Yin, S.P.; Peng, C.; Jin, Z.Y. (2017) Research on mechanical properties of axial-compressive concrete columns strengthened with TRC under a conventional and chloride wet-dry cycle environment. J. Compos. Constr. 21 [1], 04016061. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000725
Xu, S.L.; Li, Q.H.; Li, H.D. (2008) An experimental study on the flexural properties of carbon textile reinforced ECC. Chin. Civil. Eng. J. 40 [12], 69-76.
American Concrete Institute. (2013) Guide to design and construction of externally bonded fabric Reinforced Cementitious Matrix (FRCM) systems for repair and strengthening concrete and masonry structures. ACI 549.4R-13, ACI Committee 549. Farmington Hills, MI.
Trapko, T. (2014) Confined concrete elements with PBOFRCM composites. Constr. Build. Mater. 73, 332-338. https://doi.org/10.1016/j.conbuildmat.2014.09.055
Teng, J.G.; Huang, Y.L.; Lam, L.; Ye, L.P. (2007) Theoretical Model for Fiber-Reinforced Polymer-Confined Concrete. J. Compos. Constr. 11 [2], 201-210. https://doi.org/10.1061/(ASCE)1090-0268(2007)11:2(201)
Pan, Y.; Cao, S.Y.; Jing, D.H.; Chen, D.B. (2009) Test and analysis of the axial stress-strain relationship of square section concrete columns confined by CFRP under preload. Chin. Civil. Eng. J. 42 [1], 23-29.
Pan, Y.; Guo, R.; Li, H.G.; Tang, H.Y.; Huang, J.X. (2017) Analysis-oriented stress-strain model for FRP-confined concrete with preload. Compos. Struct. 166 [3], 57-67. https://doi.org/10.1016/j.compstruct.2017.01.007
Yin S.P.; Xu, S.L.; Lv H.L. (2014) Flexural Behavior of Reinforced Concrete Beams with TRC Tension Zone Cover. J. Mater. Civ. Eng. 26 [2], 320-330. https://doi.org/10.1061/(ASCE)MT.1943-5533.0000811
Trapko, T. (2014) Effect of eccentric compression loading on the strains of FRCM confined concrete columns. Constr. Build. Mater. 61, 97-105. https://doi.org/10.1016/j.conbuildmat.2014.03.007
Published
How to Cite
Issue
Section
License
Copyright (c) 2019 Consejo Superior de Investigaciones Científicas (CSIC)
This work is licensed under a Creative Commons Attribution 4.0 International License.
© CSIC. Manuscripts published in both the print and online versions of this journal are the property of the Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.
All contents of this electronic edition, except where otherwise noted, are distributed under a Creative Commons Attribution 4.0 International (CC BY 4.0) licence. You may read the basic information and the legal text of the licence. The indication of the CC BY 4.0 licence must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the final version of the work produced by the publisher, is not allowed.
