Efecto de la especie en la resistencia a la pudrición de la madera expuesta al exterior fuera del contacto con el suelo en España
DOI:
https://doi.org/10.3989/mc.2021.11320Palabras clave:
Madera, Durabilidad, Envejecimiento, Permeabilidad, Detección de fisurasResumen
El objetivo del estudio es evaluar el efecto de la especie en la resistencia de la madera frente a la pudrición y proponer valores de corrección de la dosis crítica. Para evaluar el factor especie, se analizó la evolución del número de días anuales con contenido de humedad superior al 18% en piezas de madera aserrada de 20x100x750 mm3 de los pinos Laricio, silvestre y radiata así como en Abeto rojo, Eucalipto (globulus) y castaño europeo durante los años 2016, 2017 y 2018, expuestas en siete localidades españolas elegidas por tener los climas más representativos. Se propone un valor de 1.0 para las cuatro coníferas, 2.51 para el eucalipto y 1.84 para el castaño. No fue posible diferenciar entre el efecto debido a la diferente capacidad de sorción/desorción de cada madera de aquél motivado por la diferente propensión al fendado, teniendo que ser integrados ambos aspectos en un único “factor especie”.
Descargas
Citas
Brischke, C.; Jones, D. (2016) Performance of bio-based building products - Recent activities within COST Action FP 1303; Holztechnologie. 57 [2], 47-54.
Brischke, C.; Rapp, A.O.; Bayerbach, R. (2007) Decay influencing factors: a basis for service life prediction of wood and wood-based products. Wood. Mat. Sci. Eng. 1 [3-4], 91-107. https://doi.org/10.1080/17480270601019658
Meyer-Veltrup, L.; Brischke, C. (2017) Design and performance prediction of timber structures based on a factorization approach. IRG/WP 17-20603. IRG; Stockholm.
Thelandersson, S.; Isaksson, T.; Frühwald, E.; Toratti, T.; Viitanen, H.; Grüll, G.; Jermer, J.; Suttie, E. (2011) WoodExter-Service life and performance of exterior wood above ground. Report TVBK‐3060. ISBN 978‐91‐979543‐ 0‐3. Lund University; Sweden.
Isaksson, T.; Thelandersson, S. (2013) Experimental investigation on the effect of detail design on wood moisture content in outdoor above ground applications. Build. Environ. 59, 239-249. https://doi.org/10.1016/j.buildenv.2012.08.023
Isaksson, T.; Thelandersson, S.; Jermer, J.; Brischke, C. (2015) Service life of wood in outdoor above ground applications: Engineering design guideline. Background document Rapport TVBK-3067. Lund University; Division of Structural Engineering; Lund; Sweden. ISBN 978-87993-02-2.
EN 252:2015 Field test method for determining the relative protective effectiveness of a wood preservative in ground contact. European Committee for Standardization.
ISO 15686-1 (2011) Buildings and constructed assets - Service life planning - Part 1: General principles and framework. International Organization for Standardization; Genève.
Marteinsson, B. (2003) Durability and the factor method of ISO 15686-1. Build. Res. Inf. 31 [6], 416-426. https://doi.org/10.1080/0961321032000105412
Fernandez-Golfin, J.I.; Larrumbide, E.; Ruano, A.; Galvan, J.; Conde, M. (2016). Wood decay hazard in Spain using the Scheffer index: proposal for an improvement. Eur. J. Wood Prod. 74, 591-599. https://doi.org/10.1007/s00107-016-1036-z
Isaksson, T.; Brischke, C.; Thelandersson, S. (2013) Development of decay performance models for outdoor timber structures. Mater. Struct. 46, 1209-1225. https://doi.org/10.1617/s11527-012-9965-4
Brischke, C.; Hesse, C.; Meyer, L.; Bardage, S.; Jermer, J.; Isaksson, T. (2014). Moisture dynamics of wood- An approach to implement the wetting ability of wood into a resistance classification concept. Proceedings IRG annual meeting 2014. IRG/WP 14-20557. IRG; Stockholm.
Meyer-Veltrup, L.; Brischke, C.; Goritzka, C.; Hundhausen, U. (2016). Formation of cracks in wooden elements - design; moisture and durability aspects. COST FP 1303 4th Conference 'Designing with bio-based building materials - challenges and opportunities' 24-25 February 2016; Madrid; Spain.
Osawa, T.; Maeda, K.; Tsunetsugu, Y.; Shida, S. (2019). Influence of surface checks on wood moisture content during wetting and re‑drying. Eur. J. Wood Prod. 77, 681-689. https://doi.org/10.1007/s00107-019-01423-w
Brischke, C.; Soetbeer, A.; Meyer-Veltrup, L. (2017). The minimum moisture threshold for wood decay by basidiomycetes revisited. A review and modified pile experiments with Norway spruce and European beech decayed by Coniophora puteana and Trametes versicolor. Holzforschung. 71 [11], 893-903. https://doi.org/10.1515/hf-2017-0051
Rapp, A.O.; Peek, R.D.; Sailer, M. (2000). Modelling the moisture induced risk of decay for treated and untreated wood above ground. Holzforschung. 54 [2], 111-118. https://doi.org/10.1515/HF.2000.019
Råberg, U.; Edlund, M.L.; Terziev, N.; Land, C.J. (2005) Testing and evaluation of natural durability of wood in above ground conditions in European overview. J. Wood Sci. 51, 429-440. https://doi.org/10.1007/s10086-005-0717-8
Meyer, L.; Brischke, C. (2015). Fungal decay at different moisture levels of selected European-grown wood species. Int. Biodeter. Biodegr. 103, 23-29. https://doi.org/10.1016/j.ibiod.2015.04.009
Morris, P.; Winandy, J.E. (2002). Limiting Conditions for Decay in Wood Systems. International Research Group on Wood Protection; Stockholm; IRG/WP 02-10421. IRG; Stockholm.
Zak, J.C.; Wildman, H.G. (2004). 14 - Fungi in stressful environments. In Biodiversity of fungi. Burlington: Academic Press; 303-315. https://doi.org/10.1016/B978-012509551-8/50017-9
Viitanen, H.A. (1997) Modelling the time factor in the development of brown rot decay in Pine and Spruce sapwood-the effect of critical humidity and temperature conditions. Holzforschung. 51, 99-106. https://doi.org/10.1515/hfsg.1997.51.2.99
Kutnik, M.; Suttie, E.; Brischke, C. (2014) European standards on durability and performance of wood and wood-based products - Trends and challenges. Wood Mater. Sci. Eng. 9 [3], 122-133. https://doi.org/10.1080/17480272.2014.894574
Brischke, C.; Humar, M.; Meyer, L.; Bardage, S.; Van den Bulcke, J. (2014). Cost Action FP 1303. Cooperative Performance Test. Instructions for participants.
Fernandez-Golfin, J.I.; Conde, M.; Conde, M.; Fernandez- Golfin, J.J.; Calvo, R.; Baonza, M.V.; de Palacios, P. (2012). Curves for the estimation of the moisture content of ten hardwoods by means of electrical resistance measurements. Forest Syst. 21 [1], 121-127. https://doi.org/10.5424/fs/2112211-11429
Fernández-Golfín, J.I.; Conde García, M.; Fernández-Golfín, J.J.; Conde García, M.; Hermoso, E.; Cabrero, J.C. (2014). Effect of temperature of thermotreatment on electrical conductivity of radiata pine timber. Maderas. Cienc. Tecnol. 16 [1], 25-36.
Conde García, M.; Conde García, M.; Fernández-Golfín, J.I. (2020). Improving the performance of wood moisture content measuring devices by new calibration curves for four European softwoods growing in Spain. Wood mater Sci. Eng. (In edition).
Forsén, H.; Tarvainen, V. (2000). Accuracy and functionality of hand held wood moisture content meters. VTT publications num. 420. 95 pp. ISBN 951-38-5581-3.
EN 1995-1-1:2016 Eurocode 5: Design of timber structures - Part 1-1: General - Common rules and rules for buildings.
Ministerio de Fomento (2009). Documento Básico SE-M Seguridad Estructural Madera. Código Técnico de la Edificación (in Spanish).
Johansson, P.; Bok, G.; Ekstrand-Tobin, A. (2013). The effect of cyclic moisture and temperature on mould growth on wood compared to steady state conditions. Build. Environ. 65, 178-184. https://doi.org/10.1016/j.buildenv.2013.04.004
ISO 4628-4 (2004): Paints and varnishes - Evaluation of degradation of coatings - Designation of quantity and size of defects; and of intensity of uniform changes in appearance - Part 4: Assessment of degree of cracking.
ISO 4469:1981 Wood - Determination of radial and tangential shrinkage. International Organization for Standardization.
Fernández-Golfín Seco, J.I.; Conde García, M. (2007). Manual técnico de secado de maderas. 2019 p. ISBN 978-84-87381-37-9. Asociación de Investigación Técnica de las Industrias de la Madera y el Corcho (https://infomadera.net/modulos/publicaciones.php?id=6&claseact=publicaciones).
Bengtsson, C. (2001). Variation of moisture induced movements in Norway spruce (Picea abies). Ann. For. Sci. 58, 569-581. https://doi.org/10.1051/forest:2001146
Publicado
Cómo citar
Número
Sección
Licencia
Derechos de autor 2021 Consejo Superior de Investigaciones Científicas (CSIC)
![Creative Commons License](http://i.creativecommons.org/l/by/4.0/88x31.png)
Esta obra está bajo una licencia internacional Creative Commons Atribución 4.0.
© CSIC. Los originales publicados en las ediciones impresa y electrónica de esta Revista son propiedad del Consejo Superior de Investigaciones Científicas, siendo necesario citar la procedencia en cualquier reproducción parcial o total.Salvo indicación contraria, todos los contenidos de la edición electrónica se distribuyen bajo una licencia de uso y distribución “Creative Commons Reconocimiento 4.0 Internacional ” (CC BY 4.0). Puede consultar desde aquí la versión informativa y el texto legal de la licencia. Esta circunstancia ha de hacerse constar expresamente de esta forma cuando sea necesario.
No se autoriza el depósito en repositorios, páginas web personales o similares de cualquier otra versión distinta a la publicada por el editor.
Datos de los fondos
Ministerio de Economía, Industria y Competitividad, Gobierno de España
Números de la subvención BIA2013-42434-R